气相色谱-串联质谱法测定沉积物中多环芳烃

采用ASE法提取沉积物中16种多环芳烃,以固相萃取法净化提取液,用气相色谱-串联质谱法测定。通过优化测定条件,使方法在5.00μg/L~1 600μg/L范围内线性良好,方法检出限为0.15μg/kg~0.66μg/kg。空白石英砂的加标回收率为61.9%~121%,7次测定结果的RSD为2.6%~11.1%。     

Pressurized liquid extraction of six tetracyclines from agricultural soils

Veterinary antibiotics used in agriculture can be introduced into the environment through land application of animal manure, accumulating in soils and groundwaters and posing a significant risk to human health and animal well-being. As the analysis of tetracyclines in soil is challenging due to their strong interaction with soil minerals and organic carbon, the objective of this study was to develop a reliable and reproducible method for quantitative analysis of chlortetracycline and oxytetracycline, and their respective metabolites in soils. A method based on pressurized liquid extraction (PLE) with in-cell clean-up was developed for the extraction of chlortetracycline and oxytetracycline and four likely metabolites from a set of four soils. Optimized conditions included a cell size of 22?mL, soil loading of 5?g, pH of 8.0, methanol:water ratio of 3:1, 50?°C, and two cycles. Soil extracts were analysed by high-performance liquid chromatography (HPLC) coupled with ion trap mass spectrometry (MS). Recoveries of seven tetracyclines from soil ranged from 41% to 110%. The limits of detection for tetracyclines were 0.08–0.3 µg g^?1 soil, and intra- and inter-day variation ranged from 0.12–0.34%. The proposed PLE method is suitable for quantification of tetracyclines in agricultural soils at typical concentrations expected in contaminated environments.     

ASE-气相色谱法测定油田区土壤中多种石油烃

采用气相色谱法测定油田区土壤中C_(10)～C_(40)的石油烃,通过优化加速溶剂萃取的条件,使方法在62 mg/L～3 100 mg/L范围内线性良好,方法检出限为4.8 mg/kg。用该方法测定石油区短期、中期、长期油井污染土壤样品,5次测定结果的RSD为1.3%～5.2%,加标回收率为84.8%～98.5%,有证标准样品测定结果在可信区间内。     

顶空-气相色谱法(氮磷检测器)测定固定污染源废气中三甲胺

建立了顶空-气相色谱法测定固定污染源废气中三甲胺的分析方法。弱酸性吸收液采集固定污染源废气中的三甲胺,碱液中和后顶空进样气相色谱仪氮磷检测器分析。并对平衡温度、平衡时间、盐析效应、氨水和氢氧化钠条件实验进行优化,在最佳实验条件下,三甲胺的方法检出限为0. 46μg/m~3(以采集20 L空气样品计),加标回收率为97%～107%,相对标准偏差在9. 26%以下。利用该方法对垃圾焚烧发电厂厂界空气及鱼粉厂有组织废气中三甲胺进行检测分析,该方法能够满足国家标准及上海地方标准中三甲胺排放限值的要求。     

气相色谱法测定水质中的内吸磷

优化了气相色谱法测定水质中的内吸磷,当取样量为100 m L时,内吸磷-O方法检出限为0. 30μg/L,测定下限为1. 20μg/L;内吸磷-S方法检出限为0. 80μg/L,测定下限为3. 20μg/L。内吸磷-O和内吸磷-S标准曲线线性良好,相关系数分别为0. 999 2和0. 999 8。不同水质中内吸磷-O的加标回收率为90. 3%～104%,相对标准偏差为3. 6%～9. 2%;内吸磷-S的加标回收率为92. 1%～94. 9%,相对标准偏差为4. 6%～8. 7%。该方法灵敏度高,能有效分离内吸磷-O和内吸磷-S,同时能将内吸磷-O、内吸磷-S与其他有机磷农药类干扰物分离。     

Grab and passive sampling applied to pesticide analysis in the São Lourenço river headwater in Campo Verde – MT,Brazil

In this study, the quality of surface water in the headwaters of São Lourenço River in Mato Grosso, Brazil, was evaluated in relation to contamination by pesticides. For this purpose, samples were collected between December 2015 and June 2016 by grab sampling and by passive sampling using an integrative polar organic compound sampler installed in the field during four 14-day cycles between March and June 2016. The analyses were performed by gas chromatography (CG/MS) and by liquid chromatography (UPLC-MS/MS). The results showed the detection of two pesticides (atrazine and pyraclostrobin) of the five analyzed by passive sampling and eight active principles among the 20 analyzed (malathion, diuron, carbofuran, carbendazim, trifluralin, imidacloprid, metolachlor, and acetamiprid) by grab sampling. The detection of 10 pesticides, even almost a decade after the beginning of a recovery process of the ciliary forest, confirms the headwaters' vulnerability to these contaminants and passive sampling proved to be an important tool in capturing small concentrations of pesticides constituting an interesting complement to grab sampling.     

钻屑法测定煤层H_2S含量

为了测定煤层硫化氢(H2S)含量,防治矿井H2S涌出,提出一种通过钻屑法测定煤层H2S含量的方法。在未受采动影响的新鲜煤壁,采用钻屑法取样,通过测定煤样H2S解吸量、取样过程损失量和H2S残存量确定煤层H2S含量。根据溶于水中H2S的p H值和色谱分析解吸气体中H2S体积分数,确定H2S解吸量;根据煤样解吸规律和气样H2S体积分数,确定H2S损失量;根据色谱分析残存气体中H2S体积分数,确定其残存量。用此方法,对山西某矿H2S涌出煤层进行现场和实验室测定。研究表明,该矿H2S含量为(4.465~6.701)×10-3m3/t。钻屑法测定煤层H2S含量是可行的,可以为矿井H2S治理提供基础数据。     

高效液相色谱-三重四级杆/复合线性离子阱质谱法测定饮用水中22种邻苯二甲酸酯

建立了一种同时测定饮用水中22种邻苯二甲酸酯(PAEs)的高效液相色谱-三重四级杆/复合线性离子阱质谱方法:饮用水样品经针头过滤器过滤,选用Biphenyl液相色谱柱进行分离,以含0.1%甲酸的水溶液和含0.1%甲酸的甲醇溶液为流动相,电离模式为电喷雾正离子,选用多反应监测触发增强子离子扫描模式进行检测。结果表明,22种PAEs的灵敏度良好,定量限为0.001～0.1 μg/L。配制浓度为0.1～100.0 μg/L的混标溶液进行进样分析,分析结果显示,22种PAEs在该范围内的线性关系良好,相关系数均大于0.995,方法的平均回收率为82.9%～108.9%,相对标准偏差为0.9%～11.2%。同时,使用增强子离子扫描谱图进行搜库匹配,定性准确性高。该方法适用于饮用水中PAEs的检测。     

基于ACF-AMDF的气井环空液面回波特征提取方法

为了精确有效地提取声波法检测气井环空液位的回波周期，在分析环空中测试波的传播特征及基音周期检测的基础上，提出1种基于检测信号短时自相关函数(ACF)及平均幅度差函数(AMDF)的液面回波周期提取方法；利用自主搭建的室内模拟实验系统开展了不同初始环空压力下环空液位检测实验；对检测信号进行中心削波处理并计算ACF/AMDF，提取出液面回波周期并与理论计算值对比分析；同时分析了现场环空液位检测信号，提取其回波周期。研究结果表明:提出的新方法能有效地用于提取环空液面回波周期；室内实验中，该方法最大误差绝对值为1.54%；该方法能够有效抑制液面回波信号中的随机噪声及接箍反射波等，处理后的信号曲线在回波周期处峰值更加突出、集中，而在其他位置更加平滑，提高了对液面回波周期特征的辨识能力。     

Morphological characteristics of flashing jet throughout superheated liquid release

Many release problems involve two-phase releases of hazardous materials of superheated liquids with high energy into the atmosphere. Such accidents are accompanied by violent phase transition and form catastrophic flashing jets. In this work, experimental and theoretical analyses were conducted to investigate dynamic characteristics of flashing jet morphology and their dependence on pressure-decay dynamics under different storage pressures, superheats, and nozzle diameters. Flashing jet morphology and angle throughout two-phase releases were captured by a high-speed camera, and the corresponding source pressure in the superheated liquid tank was measured simultaneously. Results show that three typical phases, expansion, stabilization, and decay, are characterized throughout two-phase release based on the evolution of flashing jet morphology. The jet initially expands gradually due to the enhancement of phase transition intensity, and then keeps stable when the intensity reaches its maximum, and terminally decays rapidly due to the depletion of superheated liquid. Phase transition intensity at the nozzle exit is mainly controlled by the pressure-decay dynamics. Bubbles nucleation inception sites gradually move upstream of the nozzle during the pressure decay process increasing the phase transition intensity. The increase of storage pressure, superheat and nozzle diameter promotes the mechanical and thermodynamic effects on the jet breakup. The significant increase of mechanical and thermodynamic effects effectively accelerates droplets evaporation and further affects flashing jet morphology.